An electronic cylinder with a connection interface in accordance with ISO 15552. The type we offer here has a 50mm bore.The piston rod extension is controlled by a system with a hardened ballscrew and recirculating ball screw nut. The type we offer here has a 5mm pitch. In this 50mm bore size we can make a pitch of 5mm, 10mm and 16mm. The cylinders can be custom made to your requested dimensions. This particular model has a 150mm stroke, but also this can be customized to your wishes. To be able to use accessoires like hinges, it's better you use the gearted model like we offer it here. The gear ratio is 1 to 1, and the gearbox allows you to mount the hinge on the bottom of it. When you use the inline models, there is no possibility to mount the hinges on the stepper or servo motor,so in that case only a center hinge is possible. The type we offer here has an built in, anti rotation system. Which means the M16 thread is not free to rotate (like it is on a pneumatic cylinder), for many applications this is handy, but also this can be customized to your choice. The degree of protection can be IP40 or IP55-65. We offer it here with IP55-65, and that's also what we would advise doing for custom projects. The price difference is very small,and it means your ballscrew is better protected against water, and dust etc. The electronic cylinders can be customized to fit your servo or stepper motors of choice. The type we offer here has a 60x60 flange, and allows you to mount standard 60x60 servomotors with a 14mm shaft diameter. We have also made other custom cylinders, where the flanges is made for a 80x80 servo or NEMA34 steppers. A fully custom solution is possible. Contact us for an offer in that case. It is also important to know that we always really do calculations to properly size these electronics cylinders together with the drive system. The fact that it has a 60x60 flange does not mean that you can install every 60x60 servomotor. For this type with a 5mm pitch we recommend a maximum torque of 1,27Nm. We then have a nominal output force of approximately 1436 Newtons and a piek force of 4308N for short intervals. (300% boost)

Component features:

• Electronic Cylinder ISO-15552
• Bore: 50mm
• Stroke: 150mm
• Diameter of ballscrew: 16mm
• Pitch of ballscrew: 5mm
• Inline or geared version: Geared (ratio is 1 to 1)
• Anti Rotation
• Degree of protection: IP55-IP65
• Flange: suitable for 60x60servo motors with a 14mm shaft diameter (Delta and many other brands)
• Maximum speed: 250mm/s (15000mm/min)
• Maximum input torque: 1,27Nm (nominal, 300% boost allowed for short intervals)
• Nominal axial force delivered: 1436N (approximately 146.38kg pushing force)
• Maximum axial force delivered: 4308N (approximately 439.14kg pushing force)
• Brand: MetalWork
• Made in Italy