G30 gliding element for TCM diameter 30mm

This is an optional gliding element, for the ECOCAM TCM (4,3,2,1), that sometimes replaced the G20 (standard) gliding element. The area in contact with the cutting materiaal, is more, so there is less surface pressure on the material. The taper of the edge is the same as on the G20. We advise this gliding element, when cutting fragile materials, where less surface pressure is required to prevent damage to the material. Sometimes its better to increase surface area, and then also increase spring pressure. Which means you have a higher force on material, but same or lower surface pressure, as its spread over a larger surface area.

Component features:

• Compatible with ECOCAM Tangential Cutting Module TCM-4 (also old models TCM3 and 2)
• Outside diameter: 35mm
• Gliding diameter: 30mm (area in contact with material)
• Length: 25mm
• This is an optional gliding element, that sometimes replaced the G20 (standard) gliding element.
• Because of the larger diameter in contact with the material, the surface pressure is lower.