Tool - SAC BIT M12-D20 - 1208445

Nut for assembling sensor/actuator cables with M12 connector and M12 connectors for assembly, knurl diameter: 20 mm, for 4 mm hexagonal drive. By combining this with a 0.4Nm torque wrench you can tighten the M12 connectors with the right torque. This particular type with the 20mm diameter is most commonly used on connectors that can be assembled by hand, so screw terminals or push in. It us not very common on the pre-made over moulded connectors.

Component features:

• Suitable for use with M12  series, connectors with 20mm diameter knurl
• By using this part together with a torque wrench, you can be sure that the connectors are tightened with the correct torque, and are therefore truly IP65 sealed.
• NOTE: this is only the attachment, a 0.4Nm torque wrench is also required.
• Phoenix Contact article number: 1208445
• Phoenix Contact Product name: Tool - SAC BIT M12-D20 - 1208445